When my local Evinrude E-TEC dealer contacted me about reviewing an E-TEC 50 outboard motor, the test was made all the more interesting in that it was a re-power engine for a 1998 Quintrex 435 Top Ender. The boat’s owner had originally bought the Quintrex along with a 50 hp four-stroke outboard, but as the engine clocked up the hours, it became increasingly expensive to service.

Instead of opting for another four-stroke boat engine, the owner chose an E-TEC 50. This decision was based on the three-year or 300-hour no-service period, and that, essentially, being a two-stroke engine, there was a lot less to go wrong. The E-TEC 50 outboard has no belts to stretch or fail and uses the same pistons and con rods as E-TEC outboards from 40 to 200hp. One of my colleagues, who has owned an E-TEC 50 engine on his Webster Twinfisher for some time now, says it’s been very reliable during countless fishing trips.

The Evinrude E-TEC 50 outboard is the middle of a trio of twin-cylinder models from 40 to 60hp. Only the E-TEC 60 differs in that it has a two-stage exhaust system to increase top-end power. Like its counterparts, the Evinrude E-TEC 50 outboard has a mix of stratified and homogenous combustion with the changeover point at 1500 rpm.

When operating in stratified mode, the fuel is sprayed into the combustion chamber in a narrow conical shape with the overall combustion air/fuel ratio being as lean as 70:1. In homogenous mode, the A/F ratio is around 14.7:1, which is necessary to provide the torque to plane a hull. Depending on the load requirements and engine rev rate, the fuel-injection pressure varies from 500 to 700psi (34 to 48bar) achieved through electrically-controlled unit injectors.

Oil is injected by an electric pump only where it’s needed, and when the engine is set up to run on fully synthetic Evinrude XD100 oil, the fuel/oil ratios are very lean.

The variable voltage under the flywheel alternator produces up to 25 amps of dedicated battery charging current, while the Speed Adjusting Failsafe Electronics (SAFE system) automatically reduces engine rpm to a “limp home” mode in the event of no oil or engine overheat situations. The engine can also be started manually in the event of a flat battery as the EFI system doesn’t require a battery to function.

Performance

Spinning a 15in pitch stainless steel Viper prop, the review Evinrude E-TEC 50 was a perfect match for the Top Ender and had blistering acceleration across its entire rev range. This was despite the fact that it was pushing 700kg including two adults, the owner’s bowmount Minn Kota trolling motor and deep cycle battery, and a full underfloor fuel tank. It started instantly hot or cold and despite running on a rich “break-in” mix (first two hours) there was no oil smoke, and only a slight oil smell when backing upwind. Providing the antiventilation plate was kept at least three quarters immersed, power astern was good and the multifunction tiller arm was very user-friendly. Vibration levels were surprisingly low for a big twin, even when trolling.

The Evinrude E-TEC 50's minimum planing speed was 12.4kts (23.0 km) at 3500rpm. 16.6kts (30.8 kmh) was attained at 4000rpm, using 8.9lt/h. WOT gave 27.5kts (51.0 km) at 5720rpm at 19.3lt/h.

Through full-lock figure-of-eight turns at 4000 rpm, no prop ventilation occurred. However, due to the prop steer torque from the massive gearcase reduction ratio the steering was very heavy until the outboard leg was trimmed out slightly. At WOT we could hold a normal conversation at the helm. How about that?

Servicing and Warranty

Powerhead access is tight, but the lower cowl splits in half for full servicing. Unlike the direct DFI two-stroke competition, the upper cowl must be removed to access the integral oil tank. It’s a sensible design that prevents salt spray from reaching the tank cap. Although servicing is not essential for the first 300 hours or three years, I recommend changing the gear oil annually. The recreational-usage warranty is five years.

 

Competing Outboards

ENGINE

Tohatsu TLDI 50

DRY WEIGHT

96kg

WARRANTY

3 years

OEDA STARS

3 stars

Evinrude E-TEC 50 Tiller Steer Best Features

  • Gutsy and fuel efficient.

  • Quiet and user-friendly.

  • Very low servicing requirements.

  • Great spares availability.

 

Originally published in TrailerBoat #264, December 2010 / January 2011.

Ready to Set Sail? 

Find your dream boat online at Only Boats! We have great deals on boats for sale, including used boats and new boats. You can also check out our used boat buying guide.

If you're upgrading or planning to sell your boat, why not explore our expert guide on how to improve boat resale value. If you're planning to attend a boat show soon, we've also put together a detailed boat show buying guide that's perfect for first time buyers.

Smooth sailing starts with the right boat. We’re here to help you find it!

 

This article was written by Andrew Norton and previously appeared at TradeaBoat.com.au, now powered by Only Boats.


Found your perfect purchase? Let’s make financing just as easy!

Work with Australia’s best-reviewed finance broker for a great deal and a stress-free experience. With 3,000+ glowing Google reviews, you can trust you're in good hands! See what our happy customers say in Credit One reviews, or jump right in and crunch the numbers with our handy loan repayment calculator. Your ideal financing solution is just a few clicks away!